You shouldn’t have to glue the stem of the spoon into the tubing as it should hold and it helps cleaning it a lot easier, however some do. Feed the stem of the spoon into the tube opening at the base and position the spoon over the urethra and then practice in the shower or somewhere getting this location just right. Cut the end of the plastic baby spoon off leaving 1 inch of the stem of the spoon. Pass the tubbing through the packer leaving excess tubbing either end hanging out for now. This will allow more stretch once the tube is inserted and also stop the packer disintegrating on initial use. Immediately after this, run cold water through the new hole in the packer. It should pass through like a knife through butter. Heat up a screwdriver or a skewer ( a tea towel may come in handy) with a lighter or something and then press through the packer beginning at the tip of the packer down through to the base. Mark the centre of the front of your packer with a dot and the centre of it at the back. The above materials if they can’t be located at home may set you back no more than $10 on eBay and a MASHO packer an additional $15 but already you have the materials present in a $50 to $60 STP model. 1 rubbery/bendable baby medicine spoon.Medical rubber tubing 1/16th inch thick for flexibility with opening diameter around 1/2 to 5/8th of an inch.1 normal packer – a 3 or 4 inch MASHO will suffice.4 Ideas for what & where to get a decent STP prosthetic.4 Tips for tailoring your homemade STP packer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |